Introduction of Vertical Machining Center

Vertical Machining Center refers to a machining center wherever the axis of the spindle is perpendicular to the work table. Next, let’s take a look at the introduction of Vertical Machining Center. Here are some answers.

Here is the content list:

• Lubrication system of Vertical Machining Center.

• The distinction between Vertical Machining Center and Horizontal Machining Center.

Lubrication system of Vertical Machining Center

Simply put, the Vertical Machining Center lubrication system is to combines singly equipped grease and compressed gas to create a turbulent air-air mixed-flow so offer it to the most shaft a part of the machining center or alternative lubrication elements. The Vertical Machining Center uses the flow of compressed air in the pipeline to drive the lubricating oil to flow continuously along the inner wall of the pipeline, mix and transport the oil and gas to the main shaft part of the machining center and the lead screw and other parts that need lubrication. The dry compressed air is continuously supplied at constant pressure (5-8BAR), and the lubricating oil is supplied quantitatively according to the difference of the spindle lubrication, screw lubrication, or other parts of the oil consumption. Therefore, every lubrication circuit should use a separate small pump because of the power supply for oil delivery. The oil should 1st enter the oil-air combination valve when it comes out of the pump. Within the oil-air mix valve, the flowing compressed gas blows the oil into fine oil droplets and adheres. Associate in nursing oil film is made on the pipe wall, and also the oil film flows on the pipe inclose the direction of the airflow throughout the flow, the thickness of the oil film step by step decreases, however it doesn't condense.

The distinction between Vertical Machining Center and Horizontal Machining Center

Vertical Machining Center

Vertical Machining Center refers to a machining center with a vertical spindle. The work table is rectangular and has no compartmentalization and rotation operation. It's appropriate for process discs, sleeves, and plate elements. It usually has 3 linear motion coordinates. Axis and a rotary table rotating on a horizontal axis are often put in on the work table to method spiral elements. Vertical Machining Center is straightforward to put in, straightforward to work, straightforward to watch the process conditions, straightforward to right the program, and widely used. However, restricted by the peak of the column and also the tool changer, elements that square measure too high can't be machined. Once machining the cavity or dish-shaped profile, the chips aren't straightforward to discharge. In severe cases, the tool is going to be broken, the machined surface is going to be broken, and also the sleek process is going to be affected.

Horizontal machining center

A horizontal machining center refers to a machining center with a horizontal spindle. It usually has three to five motion coordinates. The common one is 3 linear motion coordinates and one move coordinate. Once the cardboard is put in once, the process of the remaining four surfaces apart from the mounting surface and also the prime surface is completed. It's most fitted for adding box elements. Compared with the Vertical Machining Center, the horizontal machining center is straightforward to get rid of chips throughout machining, which is helpful to the machining, however, the structure is difficult the worth is higher.

If you are interested in Vertical Machining Center, you can contact us. Our website is https://www.saintymachine.com/.